Thermal Vitality Mask Warmer ANESI

Description

Directions for Use:

1. Place the metal mask container into the professional heater.
2. Set the device to operating mode and turn the thermostat to maximum heating for 5–10 minutes.
3. Afterward, reduce the heat by setting the thermostat to level 4 or 5.
   • Note: Adjust the thermostat according to the remaining amount of product in the container.
4. Melting a full container takes approximately 25 minutes. You may begin application once the mask starts melting from the sides of the container.
5. Safety Check: Before applying to the face, test the temperature on your wrist to ensure it is not too hot.
6. Use a spatula to apply the mask, starting from the neck and moving gradually across the cheeks toward the center of the face.
   • Important: Ensure the edges are even and the layer thickness is between 3–5 mm.

Professional Synergy:

• Before applying the thermal mask, apply Aqua Vital 3D-Aqua Serum HA+ to the skin and massage until fully absorbed.
• A prolonged massage prior to the thermal mask is highly recommended. You may use ANESI Lab Aqua Vital HA+ Massage Cream or 3D-Aqua Vital Cream HA+ for this step.